What's in the Box:
- 1 x Mounting Bracket
- 1 x Bolt 8х32 А2
- 4 x Bolt 4х8 А2
- 3 x Cable Clips
Installing onto a VPC Rotor TCS Base
Tools required:
- H2.5 Hex Key (NOT INCLUDED)
- H4 Hex Key (NOT INCLUDED)
- H5 Hex Key (NOT INCLUDED)
1. Remove the plug from the base by unscrewing the highlighted screw, install the 8x32 bolt supplied through the hole of the adapter and affix it to the base.
2. Insert the cable clips until they click into the corresponding holes on the bracket.
3. Use the supplied 4x8 bolts to secure your VPC Control Panel to the bracket. Before fully tightening the bolts, the panel can be slid forwards and backwards to find the optimum position.
* For the convenience of connecting the panel through the OUT connector to the TCS Base, we recommend reorienting the panel connectors.
Be Careful with the Internal Cabling!
Troubleshooting
Please visit the VIRPIL Controls support portal for troubleshooting advice. If you are still experiencing issues or unable to find answers to your specific question, please create a ticket on our support portal!
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article