What's in the Box:

• 1 x VPC FLNKR Grip
• 1 x FLNKR Dust Cover
• 1 x VPC Grip Stand

• 1 x 4-way cap (small)

• 2 x 4-way cap 

Attaching the Grip

1. Pull the cable from the grip by 2-3 см. 

2. Use the arrows located on the cable connector and grip socket to correctly orient the pins. Incorrect orientation will result in damage to the connectors. 

IMPORTANT! Use VPC Software to configure the device

3. Lightly tighten the screw collar and set the desired angle offset before hand tightening fully.

Wrist Rest Adjustment

1. Loosen the main adjustment dial and unscrew the small nut to the top of the wrist rest. 

2. Set your desired height using the main adjustment dial. 

3. Fix the wrist rest in place by tightening the small nut back down and then further tightening the main adjustment dial. 

H2.5 Hex hey (NOT INCLUDED) can be used as a lever to tighten the nut more firmly.

Caps replacement

Troubleshooting

Please visit the VIRPIL Controls support portal for troubleshooting advice. If you are still experiencing issues or unable to find answers to your specific question, please create a ticket on our support portal!

https://support.virpil.com